Nano Ceramic Protect Hard 9H will protect the secured car paint coating in the conditions specified below:

 

If you use a car every day, it should be a principle, that one washing a week should keep your car in a perfect condition, removing road dirt and other impurities. Some people may wash a car more often, if you do it too, remember, that the more washings, the faster there may appear micro-scratches and car-paint defects.

 

Using Nano Ceramic Protect car care products, when you wash the car once a week, will considerably reduce the risk of surface defects. All of our products have been designed so, as to supplement our coatings and help keep a perfect appearance of the car for longer.

 

Recommendations regarding washing by hand

 

It is a common misconception, that a car should be washed with a traditional sponge for car cleaning. If you look at it, it can be easily seen, that there are no possibilities there for carrying away the impurities from the car surface. Particles of dirt are trapped in the sponge, precisely between the sponge and car paint, which causes scratches. In order to prevent it, it is recommended to wash a car with the help of a glove with long hair.

 

Gloves have deep, loose structure, which helps to remove and carry away the dirt from the surface and facilitates washing. We recommend also using a glove for washing along with two buckets for washing.

 

The two buckets method is simple and consists of filling up one of them with water with shampoo, the recommended shampoo is Nano Ceramic Protect Shampoo - Super Concentrate, and the other with clean water.

 

First, we plunge the glove in the water with shampoo, wash one element, and then rinse it in clean water before we repeat the process.

 

Using impurities separator will also reduce the risk of scratching the car paint of your car. A separator at the bottom of the bucket will make it impossible for the impurities to return to the glove.

 

Washing process

 

Before you start, remember to wash your car in shade. It will prevent premature drying out of soap suds. In case it is not possible and you wash the car in the sun, you should wash one element after another.

 

Rinse the car with a relatively strong pressure, so as to remove as much dirt as possible, before washing by hand.

Nano Ceramic Protect Iron Remover - Wheel and Paint Cleaner may be sprayed on wheels or on any surface where brake dust is visible. Spray it directly on the surface and leave for 2-5 minutes. During that time all iron particles dissolve producing a red solution.

 

If the wheels are particularly dirty you can clean them with a soft ending of a brush for cleaning wheels.

In spite of the fact, that Nano Ceramic Protect coatings have very strong anti-adhesive and hydrophobic properties, tar and insect stains are an inseparable element of everyday driving. Spray Nano Ceramic Protect Tar and Glue Remover directly on the dirty areas and leave for 5-10 minutes, and then rinse.

 

The above-mentioned products can be used several times, during each washing. In extreme cases, you can use a microfiber cloth to wipe the surface. After the stage of acting on exceptional impurities (brake dust, insects, tar) it is time to start the process of hand washing. Start with the wheels and the lower parts near exhausts.

 

Fill up one bucket with water with Nano Ceramic Protect Shampoo - Super Concentrate, and the other bucket with clean water (use a separator, if you have one). Rinse out the glove in clean water, before you plunge it again in the bucket with shampoo.

 

In the course of the whole washing process, be sure to use a lot of soap suds on the glove and rinse It thoroughly. Check, that the water is not too dirty, in necessary, exchange both buckets.

 

After you have finished washing the wheels, do NOT use the same glove or the same buckets for washing your car's paint. Instead, you should use a new glove and two fresh buckets of water (one with Nano Ceramic Protect Shampoo - Super Concentrate). Brake dust is very abrasive and should be kept far from the car paint, regardless of costs.

 

Always start washing the car paint from upper surfaces (roof, bonnet, boot lid), move by turns to the bottom.

 

You have two buckets, one with Nano Ceramic Protect Shampoo - Super Concentrate, and the other with clean water (use a separator at the bottom, if you have one), plunge the washing glove in the bucket with shampoo, wash an element, then rinse with clean water.

 

In spite of the fact, that all steps are taken in order to eliminate the possible scratches, it is also important to try to effect movements along the line of the car, from the front to the back, or from side to side, avoiding circular movements. These movements cause scratches during washing. Rinse the car with clean water, so as to remove any shampoo remains.

 

Due to the coatings on the car, drying surfaces will be faster and less labor-intensive. Do not scrub nor use force while washing.

Dry all external surfaces of the car with a microfiber towel, never use real chamois leather materials for drying, because they are too hard for modern car paints and may scratch the surface.

 

It is enough to put a towel on the surface and draw towards oneself.

 

Do not leave the car until it dries, since it will cause water stains, which may damage the surface if they are not removed.

If the streaks remain, use Nano Ceramic Protect Quick Detailer - Waterless Wash & Wax and a microfiber cloth or towel for their removal.

 

After the wheels and tires have dried, apply Nano Ceramic Protect Plastic tire conditioner with the help of an applicator.